Discharge Base Ink
It is a water based printing base that obtain excellent discharging with vivid colors and soft touching effect used by discharging the color of the dischargeable fabric in textile printing
Does not dry during the print and block the screen.
If cured correctly as advised, the dry-wet rubbing and washing fastness are high.
Rubbing and washing tests should be applied 24 hours after curing.
Suitable to ecological standards.
Appearance : Transparent paste
pH : 10,5-11,5 (25 °C/ 77 °F)
Density : 1,00 g/ cm3 (25 °C/ 77 °F)
Viscosity : [(25 °C) sp: 6, rpm: 20 Brookfıeld ] : 15.000 – 17.500 [mPa.s]
Printing: After adding D3 Discharge Agent (3% to 6%) into D3 Discharge Base - WB, the paste should be consumed in 12 hours. Otherwise the paste is damaged and the colors change.
Do not use flash cure.
Screen : Silk screens that are made of 43 cm/110 inch mesh 70 micron silk - 77 cm/200 inch mesh 48 micron silk should be used.
Squeegee : 57 – 62 Shore U type squeegee should be used.
Mixture : To have discharge effect with D3 Discharge Base-WB ;
D3 Discharge Base 1000 g
WB Series Pigment 10 - 50 g
Discharge Agent 60 g
To reduce the viscosity, D3 Regulator can be added (1-3 %) into D3 Discharge Base.
Never use water to reduce the viscosity. Before use, please stir the ink well. Do not use any additives that are not advised.
After using, the screen should be cleaned with the water.
Curing : Should be cured at 160 °C/320˚F for 2 minutes.
It does not contain harmful substances for inhalation and skin when used. However in case of contact to sensitive organs, such as eyes or mouth wash with plenty of water. If necessary, medical assistance is advised.
Keep containers dry and tightly closed. Store in a ventilated place between (+5)-(+30) °C/(+41)-(+86)˚F of temperature.
There are yet no reviews for this product.