DEGREASE

Using D3 degreaser concentrate, work up a lather on both sides of mesh. Flood screen printing frame with garden type hose, then dry

COAT

Fill scoop coater with room temperature emulsion. Slowly apply first coat to print side. Then coat squeegee side with one to three coats depending upon thickness required. If thicker stencil is required, additional coats may be applied to print side after initial drying of stencil. Be sure to dry thoroughly between coats.

DRY

Thoroughly dry screen prior to exposure. Temperature should not exceed 110°F (43°C).

EXPOSE

Exposure tests must be performed on the ChromaTech®DEX emulsion to determine proper exposure times.

DEVELOP

Gently spray both sides of screen with water. Wait 30 seconds then gently wash print side of the screen until image is fully open. Rinse both sides thoroughly. Dry screen completely and you are ready to print.

RECLAIM

Apply D3 Emulsion Remover screen reclaimer, to both sides of screen. Scrub area to be reclaimed with a stiff nylon brush to ensure entire surface is wet and let it work a few moments until stencil begins to dissolve. Remove stencil residue with pressure washer, then rinse with garden type hose, thoroughly flooding screen and frame.

CHROMA/TECH DEX TDS | CHROMA/TECH DEX SDS